MCU-Linker Debug调试报 Failed on chip setup:Ep(04). Cannot halt processor

Yannick_d7928b · 发表于 2021-12-10 14:07:29

IDE 环境：MCUXpresso IDE
烧录器：MCU-Linker SWD接口
问题描述：之前可以用 MCU-Linker SWD 烧录器下载调试MCU FW，Debug时突然碰到了Failed on chip setup:Ep(04). Cannot halt processor 问题。如下：

MCUXpresso IDE RedlinkMulti Driver v11.4 (Jul 2 2021 12:03:47 - crt_emu_cm_redlink build 1)
Found chip XML file in C:/Users/micro/Documents/MCUXpressoIDE_11.4.0_6224/workspace/Project/Debug\LPC54S018.xml
Reconnected to existing LinkServer process.
Probe Firmware: MCU-LINK r0FF CMSIS-DAP V0.078 (NXP Semiconductors)
Serial Number: M0NPT1NHQTJOV
VID

ID:  1FC9:0143
USB Path: \\?\hid#vid_1fc9&pid_0143&mi_00#9&3197879e&0&0000#{4d1e55b2-f16f-11cf-88cb-001111000030}
Using memory from core 0 after searching for a good core
On debug connection - use system reset, stalling when 0x40000040 is accessed
Retask read watchpoint 1 at 0x40000040 to use for boot ROM stall
Warning - processor did not halt - gave up waiting
Cannot halt processor
Request debug reset of DAP
Cannot halt processor
Request debug reset of DAP
debug interface type    = CoreSight DP (DAP DP ID 2BA01477) over SWD TAP 0
processor type          = Cortex-*** (CPU ID 00000C24) on DAP AP 0
number of h/w breakpoints = 6
number of flash patches = 2
number of h/w watchpoints = 4
Probe(0): Connected&Reset. DpID: 2BA01477. CpuID: 00000C24. Info: <None>
Debug protocol: SWD. RTCK: Disabled. Vector catch: Enabled.
Content of CoreSight Debug ROM(s):
RBASE E00FF000: CID B105100D PID 04000BB4C4 ROM (type 0x1)
ROM 1 E000E000: CID B105E00D PID 04000BB00C Gen SCS (type 0x0)
ROM 1 E0001000: CID B105E00D PID 04003BB002 Gen DWT (type 0x0)
ROM 1 E0002000: CID B105E00D PID 04002BB003 Gen FPB (type 0x0)
ROM 1 E0000000: CID B105E00D PID 04003BB001 Gen ITM (type 0x0)
ROM 1 E0040000: CID B105900D PID 04000BB9A1 CSt TPIU type 0x11 Trace Sink - TPIU
ROM 1 E0041000: CID B105900D PID 04000BB925 CSt ETM type 0x13 Trace Source - Core
Cannot halt processor
Failed on chip setup: Ep(04). Cannot halt processor.

我知道答案目前已有1人回答

阅读全文